Reset instructions for Brother DR 6000 drum

Your step-by-step guide on how to reset your Brother DR-6000

The Brother DR-6000 drum fits many Brother printers and can be reset in a few simple steps. The Brother DR-6000 Drum Reset restarts the drum detection in the printer and resets the drum counter.

The following instructions should be followed when performing a toner reset on the printer!

• Choose the right Brother DR-6000 drum reset guide for your Brother HL series, Brother MFC series or Brother Fax series.
• Please execute the reset command quickly using the printer keyboard so that you do not fall back to the main menu while typing.
• Follow each step of the guide and don't skip a step.
• Not every Brother printer will signal successful completion with a message ("Accepted" or "Completed") after the reset.
• With the instructions you can reset original Brother DR-6000 drums and compatible drums.
• Resetting the drum prematurely can damage the device. Therefore, only reset the drum immediately after replacing it.
• In case of multiple selection, select the drum to reset.

Brother DR-6000 drum reset for Brother HL devices

1. Switch on the device
2. Open the device door
3. Press the button that is slightly recessed below the four LEDs, approximately at the level of the "Start" or "Go" button on your printer
4. Keep the button pressed
5. Wait until all four LEDs light up
6. Release the button again
7. Close the device door

The Brother DR-6000 drum reset has been performed.

Brother DR-6000 Drum Reset for Brother Fax Machine

1. Turn on the fax
2. Open the device door
3. Press the "Clear" button
4. Press key "1"
5. The display shows "successful".
6. Close the flap again

The Brother DR-6000 drum reset has been performed

Brother DR-6000 drum reset for Brother MFC machine

1. Turn on the printer
2. Open the device door
3. Press the "Cancel" button
4. Immediately press button "1".
5. The display shows "successful".
6. Close the flap again

The Brother DR-6000 drum reset has been performed