Information about Corona / Covid 19 - We are still there for you! There may still be slight delays in the delivery of the parcel service. We ask for your understanding
Refill Toner (Instructions) HP C4127X, 27X
Refill instructions for HP 27X
LaserJet 4000, LaserJet 4000 N, LaserJet 4000 SE, LaserJet 4000 Series, LaserJet 4000 T, LaserJet 4000 TN, LaserJet 4050, LaserJet 4050 N, LaserJet 4050 SE, LaserJet 4050 Series, LaserJet 4050 T, LaserJet 4050 TN
Refill toner and toner powder can be harmful to health if improperly handled. We expressly recommend the use of respiratory protection aids or vacuum devices when filling toner cartridges. In addition, toner powder and refill toner can be extremely flammable with an appropriate oxygen mixture. Also, be careful not to touch the photoconductor drum or expose it to direct sunlight. This can lead to incorrect printouts. Eurotone Office assumes no responsibility / liability for the success or failure of the procedure described below.
Place the toner cartridge in front of you as shown in the picture. Melt an approx. 1 cm hole in the cartridge at the point marked below with the help of our soldering iron with a plug welding attachment. Fill the refill toner into this hole using a funnel. Seal the hole with a piece of tissue tape. The cartridge is now full.
Carefully remove toner powder (make sure you wear gloves and a mask)
The second time you want to fill your cartridge, you should empty the waste toner box. To do this, melt a hole at the point marked below. Keep the cartridge in a trash bag. Now turn the cartridge so that the residual toner can flow out of the cartridge. The waste toner cannot be reused.
After two to three fillings, the photoconductor drum of your cartridge may begin to print streaks or a gray film. In this case it is used up.
To replace the photoconductor drum you have to disassemble the cartridge.
Safety note for handling refill toner:
Refill toner and toner powder can damage if handled improperly Cause damage to health. We recommend when filling toner cartridges expressly the use of respiratory protection aids or suction chambers. Furthermore can toner powder and refill toner with an appropriate oxygen mixture be extremely flammable. Also, make sure that you do not, under any circumstances, remove the photoconductor Touch the drum or expose it to direct sunlight. This can become buggy Print out. Eurotone assumes no responsibility for the success or failure of the described Method.