Before you start filling, please read the instructions carefully. When filling toner cartridges, we generally recommend wearing gloves and a fine dust mask.

This Brother toner cartridge is very easy to fill. Place the toner cartridge on the table in front of you. Carefully remove the label (Figure 1). Below is the sealing plug. With a spatula or a small screwdriver, you can remove the sealing plug with small lever movements (Figure 2). In some cases it is inevitable that you destroy the sealing plug in the process.

Before you fill your toner cartridge, you must remove the old toner powder. Due to different physical and chemical properties, the new and old toner can clump together. Vacuum or shake out the old toner powder into a tight plastic bag.

Filling the TYPE1200E toner cartridge - Ricoh Aficio SP 1200 s, Aficio SP 1200 Series, Aficio SP 1200 sf, Aficio SP 1210 n:

Take your refill toner bottle and screw a funnel on top. This funnel makes it easier for you to dose more precisely during filling. Fill the toner powder into the toner cartridge (Figure 3). When you have filled your toner cartridge, you can reinsert the sealing plug.

IMPORTANT: The Ricoh Aficio SP 1200, Aficio SP 1210 cartridge must be absolutely closed. Check the cartridge for leaks by tapping lightly on a piece of white paper. No toner should trickle out of the laser cartridge. Now the reset lever on the other side of the TYPE1200E toner cartridge of the Ricoh Aficio SP 1200 s Aficio SP 1200 Series Aficio SP 1200 sf Aficio SP 1210 n must be returned to its original position.

Replacing and resetting the reset lever on the Ricoh Aficio SP 1200 s, Aficio SP 1200 Series, Aficio SP 1200 sf, Aficio SP 1210 n toner cartridge:

Various Brother toner cartridges are equipped with a reset lever. The Ricoh Aficio SP 1200, Aficio SP 1210 is also included. The reset lever is a mechanical device that reliably counts down the toner level and, when the toner cartridge is empty, indicates that the cartridge needs to be refilled. Figure 4 shows you a reset lever that shows "empty", which means that the toner cartridge must be refilled. Loosen the three screws (4) marked in Figure 3 and remove the side cover.

The fifth picture shows you the inside of the side cover. Insert the reset lever as shown in Figure 5. Then you can put the side cover back on the toner cartridge and screw it tight. The reset lever should now point to the top left (Figure 6). In this position the reset lever shows "full". Your toner cartridge is now full and the reset lever is fully reset. Now you can finally print again!

Safety note for handling refill toner: Refill toner and toner powder can be harmful to health if improperly handled. We expressly recommend the use of respiratory protection equipment or suction chambers when filling toner cartridges. In addition, toner powder and refill toner can be extremely flammable with an appropriate oxygen mixture. Also, be careful not to touch the photoconductor drum or expose it to direct sunlight. This can lead to incorrect printouts. Eurotone assumes no responsibility for the success or failure of the procedure described.